Categories

Categories

Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
Netwelder

Categories

Categories

Lincoln SA-250 Engine Drive Welder (USED) K1283-8

$7,175.00

Lincoln SA-250 Engine Drive Welder (USED) K1283-8

$7,175.00
SKU:
USW U1020468004 (25)
Weight:
550.00 LBS
Shipping:
Free Shipping
Current Stock:
Out of stock
Quantity:

Out of Stock

Share

Product Description

*This welder was taken in on taken in on trade.  Please call Chad Clark at 715-845-4381 with any questions.*

 

The SA-250 is a heavy duty, engine driven, DC arc welding power source, capable of providing constant current output for stick welding or DC TIG welding. This welder is wound with all copper coils, rated at 300 amps/32 Volts. With the addition of the optional Wire Feed Module, the SA - 250 will provide constant voltage output for running the LN-7, LN-23P, or LN-25 wire feeders. The optional Remote Control Kit provides a remote control rheostat for remote fine current and open circuit voltage adjustment. The SA-250 has Diesel Engine Protection. In the event of sudden low oil pressure or high coolant temperature, the engine immediately shuts down.

 

The SA-250 has a current range of 40-350 DC amps with output ratings as follows: These units are also capable of providing 3 kVA of 115/230 volts of 60 cycle AC auxiliary power. The SA-250 uses the Perkins 104-22 industrial watercooled diesel engine. CONTROL PANEL Both the engine and the welder controls are located on one recessed panel at the exciter end of the machine. The welder controls consist of a five step “Current Range Selector” switch and a “Fine Current Adjustment” rheostat. The welder is equipped with a “Start” button, an “Ignition” switch, an “Idler” control switch, and a “Glow Plug” button for easier cold weather starting. The control panel also contains an engine temperature gauge, a battery charging ammeter, an oil pressure gauge, two three prong grounding type receptacles and four circuit breakers for auxiliary power. ENGINE IDLER - The SA-250 is equipped with an electronic automatic engine idler. It automatically increases and decreases engine speed when starting and stopping welding or using auxiliary power. A built-in time delay permits changing electrodes before the engine slows to its low idle speed. The “Idler” control switch on the panel locks the idler in high idle position when desired. AUXILIARY POWER- 3.0 kVA of nominal 115/230V, 60Hz, AC. Output voltage is maintained within ± 10% at all loads up to rated capacity.

 

image005.pngWARNING:  This product can expose you to chemicals including Hexavalent chromium, 18540-29-9 which is known to the State of California to cause cancer and Carbon monoxide, 630-08-0 which is known to the State of California to cause birth defects or other reproductive harm.  For more information go to www.P65Warnings.ca.gov.